CES 2009

Sort By: Post DateTitle Publish Date

High-End's Elder Statesmen...er, People

I can't believe that it's been 21 years since Thiel founders Jim Thiel and Kathy Gornik and I emptied the first of many bottles of fine wine talking about music and loudspeakers. But here they are, snapped outside the dem room they were sharing with Bryston and Wireworld, as passionate about audio, music, and the high-end audio industry as ever. And in the case of Kathy, looking even better than ever!


Thiel's Special Edition CS2.4

Thiel's PR wonk Micah Sheveloff grabbed me as I walked past the room in the Sands Convention Center Thiel was sharing with Bryston to meet with Frank Göbl of Canton. "You've got to hear the new CS2.4 Special Edition." As Wes Phillips had been mightily impressed by the original CS2.4 ($4900/pair) when he reviewed">http://www.stereophile.com/floorloudspeakers/1105thiel/">reviewed it in November 2005, I looked at my watch. Enough time. I went into the dem room.


A Kiss from Vienna

Taking pride of place in distributor Sumiko's suite on the Venetian's 35th floor were the new Vienna Acoustics Kiss loudspeaker ($15,000/pair). Part of the company's Klimt series, the Kiss is ostensibly a stand-mounted design, but the side-pillared, faintly convex stand is part of the design concept. One drive-unit—the flat, radially ribbed unit first seen in the Vienna Musik, covers the entire range of the human voice, 120Hz–2.6kHz, and is married to a tweeter in its center and a port-loaded woofer. The latter features the ribbed, transparent polymer cone material used in Vienna's line, but has a multiple-radius cone profile to maximize stiffness and minimize mass.


Audience Ups the Ante

I walked into Audience's room expecting to see the usal assortment of cables, power conditioners, and high-quality parts, but I was confronted with an entire Audience system, from a heavily modded Denon CD player to preamplifier, power amplifiers to loudspeakers!


Affordable TAD Monitors

Relatively affordable at $30,000/pair, that is, given the cost-no-object construction featured by TAD's new CR-1 "Compact Reference Monitor," seen here with its designer Andrew Jones and compared with the company's original floorstanding and superb-sounding Reference One from 2006. (Across the corridor from TAD, Ray Kimber was using four Reference Ones to demo his new IsoMike recordings in surround.)


Evolutionary—Revolutionary

I went into the Blue Light Audio room at T.H.E. Show to hear the new Dartzeel amplifiers (Wes Phillips will be blogging on these presently) and to chat with designer Hervé Délétraz. But my attention was caught by Evolution Audio's beautifully finished MMMini Two speakers ($40,000/pair). Ostensibly a two-way design combining a 5" aluminum ribbon with a 7" ceramic-cone woofer, the stand also contains an 8"x12" subwoofer.


Go Nad!

While I was cruising NAD's booth, I noticed the M2 Direct Digital amplifier—obviously part of NAD's Masters Series. I asked one Nad rep to tell me about it. "Oh, we didn't bring it—it's not going to be released until spring."


Canton's References

Loudspeakers from German manufacturer Canton have impressed Stereophile's review team over the past few years with their combination of careful, solid engineering and excellent sound. CES saw the launch of Canton's revised Reference line. The Reference 3.2 ($15,000/pair), seen here cradled by chief engineer Frank Göbl, features a new tweeter with a ceramic/aluminum /ceramic sandwich dome replacing the earlier version's aluminum/manganese-alloy diaphragm, which pushes up the primary dome breakup mode from around 21kHz to 30kHz. The tweeter dome is recessed within a short waveguide to optimize dispersion in its bottom octaves, and is damped by a small circular plate suspended in front of the center of the dome. The lower frequency drive-units, too, have been extensively revised, while the multilayer enclosure, with its gently curved side panels is acoustically inert, at least as far as the accelerometer measurements Frank showed me were concerned. I was sufficiently impressed to request a pair of Reference 3.2s for review.


An Honest Connection

CES presented me with my first opportunity to make the acquaintance of Stephen Hill and Straight Wire. The Florida company has just released a "push prong" re-usable, solderless RCA plug that makes Straight Wire cable termination a snap. Especially appealing to custom installers, the termination actually leads to a higher level of performance by enabling quick silver-plated termination without piercing cable insulation.


Advertisement
Advertisement
Advertisement