Music in the Round #69

Music in the Round #69

It's August as I write this, and I'm looking back at some things that need to be discussed, and forward to the fall audio shows—particularly the 2014 New York Audio Show, which, by the time you read this, will have been held in Brooklyn, September 26–28. I grew up in Brooklyn, not in "the city," Manhattan, a place that we traveled to only for special reasons. Audio shops were rare in Brooklyn—I remember only Audio Exchange—but in Manhattan there was a small cluster near Grand Central Station, there was Lafayette Radio near the Holland Tunnel, a few scattered elsewhere, and the magnet of Liberty Street in lower Manhattan, where more than two city blocks were packed with audio shops.

Simaudio Moon Evolution 820S power supply

Simaudio Moon Evolution 820S power supply

Can a power-supply upgrade produce audible sonic benefits? If you've upgraded the power supply of a phono preamplifier, you probably don't need to be convinced that it does, and those usually cost only a small percentage of the price of the model they power. But to add Simaudio's Moon Evolution 820S power supply ($8000) to the Moon Evolution 650D DAC–CD transport ($9000), which I reviewed in the November 2011 issue, almost doubles the latter's cost—though the 820S can be used to simultaneously power two Moon Evolution components, like the 750D DAC ($14,000), 740P preamplifier ($9500), and 610LP ($7500) and 810LP phono preamplifier ($13,000).

Air Tight ATM-1S power amplifier

Air Tight ATM-1S power amplifier

It's no secret, especially to those who've been following Stereophile for more than a short time: In the first half of 2007, I took the plunge and bought a Shindo preamplifier and monoblock amplifiers—handmade products characterized by low output power, generous numbers of vintage parts, steel casework finished in a signature shade of green, and richly textured, impactful sound with lots of sheer musical drive. And while we tend not to alert the major newspapers whenever someone on staff buys new electronics, the change was notable for two reasons: The compatibility of Shindo's amplifiers is limited to loudspeakers of higher-than-average sensitivity and impedance; and, throughout the seven years that followed my switch to Shindo (footnote 1) both my system and my point of view regarding domestic audio in general have evolved in the direction of the artisanal and the vintage.
Advertisement
Advertisement
Advertisement