John Atkinson

John Atkinson  |  Jan 13, 2011  |  0 comments
The electrostatic Kingsound speakers were hits at 2010 Shows, so I was anticipating good sound in the room where VAC was demming their tubed electronics with the King II speakers ($11,500/pair) and a Spiral Groove SG2 turntable and arm fitted with a Lyra Kleos cartridge. Stands were all-Symposium.)

The bugbears of electrostatic panels have been limited treble dispersion and a lack of low-frequency definition, but listening to Hans Theesink's and Terry Evans' rendition of "You Can't Tell a Book," from the LP Vision, where the guitarist and singer were accompanying themselves with footstomps, the bass remained in control and the top-octave sounded airy and spacious.

John Atkinson  |  Jan 13, 2011  |  1 comments
Sony has a track record of sporadically producing high-quality loudspeakers, like the SS-M9 that I reviewed in 1997. But as good as these speakers could be, their commercial success was limited. But at the last two Rocky Mountain Audio Fests, Ray Kimber had been getting great sound with a prototype Sony floorstander and the 2011 CES saw the official launch of the Sony SS-AR1 ($27,000/pair).

A three-way design, the SS-AR1 uses Scanspeak drive-units made to Sony's specification, housed in a unique, Japanese-made enclosure. Seen here standing next the basic enclosure, designer Yuki Sugiaro explained that the walls are made from Finnish birch ply and the front baffle from maple ply. The latter is sourced from trees grown in Hokkaido.) The woodworking is so precise that the cabinet shown here is holding itself together without any glue (thoigh glue, of course, is used on the production line).

Driven by Pass Labs amps and an EMM SACD player, the SS-AR1s were demmed in too small and crowded a room for me to pronounce on their sound quality, other than to note that the midrange seemed exceptionally clean and uncolored. But my prior experience at RMAF suggests that this will be a contender.

Availability is said to be "spring" and Sony announced that they have already signed up blue-chip US dealers like Goodwins, Definitive, David Lewis, and Music Lovers.

John Atkinson  |  Jan 12, 2011  |  0 comments
Avantgarde's Armin Kraus stands next to the new version of the three-way Duo speaker, the Grosso ($36,000/pair). Finished in "Lamborghini Orange," the Grosso substitutes two 12" woofers for the Duo's 10-inchers, and drives them with twice the amplifier power. The midrange and treble horn units are the same, but the speaker is now supported by a sturdier space-frame with spikes that are adjustable from above. And again, this is a horn speaker that offers the advantages of horns—high dynamic range, sensitivity, and "jump factor"—without the disadvantages, such as midrange coloration.
John Atkinson  |  Jan 12, 2011  |  0 comments

A highlight of my reviewing year in 2010 was living with and writing about the Acapella High Violoncello II speaker from Germany ($80,000/pair). With its horn-loaded, ionic tweeter and horn-loaded midrange unit, this speaker offered both high sensitivity and some of the most satisfyingly musical sound I have experienced in my room.

Current production has been modified a little compared with the much-traveled samples I auditioned for my review. (They were the same pair I had auditioned at the 2010 CES, Axpona and RMAF Shows.) The drive-unit complement, cabinet, and crossover are all the same, but there is now a greater range of level adjustment for the ionic tweeter and isobaric-loaded woofers. But the sound of the latest version at CES. driven by Einstein electronics, sounded just as I remembered: dynamic, transparent, neutrally balanced, and not a trace of horn colorations.

John Atkinson  |  Jan 12, 2011  |  1 comments
It was released in 2009, but Krell's Modulari Duo Reference loudspeaker ($65,100/pair) was new to me when I visited THE Show and ventured up to the 28th floor of the Flamingo. The two-box speaker features all-aluminum enclosures, and features twin port-loaded woofers and a ring-radiator tweeter. The Modularis were hooked up with Zen Satori cable to Krell's new Evolution 2250e amplifiers, which offer 250Wpc into 8 ohms and 500Wpc into 4 ohms ($20,000/pair). Also new to the Connecticut company's line at CES was the Phantom preamplifier ($17,500, or $20,000 with optional crossover module, completely adjustable for high-pass and low-pass slopes and frequencies) and the 525 CD player ($12,000 in basic form).
John Atkinson  |  Jan 12, 2011  |  0 comments
I was initially confused when I walked into this room, as there appeared to be two different systems set-up, with loudspeakers from two different manufacturers. However, playing while I was there were the new Legacy Audio Focus SE speakers in Black Pearl finish (left, $8995/pair), with the Lumenwhite Artisan speakers (not quite so left) silent. Common to both system was an Ayon Audio CD55 CD player and Synergistic Research cables, and Ayon Triton tubed monoblocks drove the Legacies.

Broadly similar in concept to the Focus 20/20 speaker that Paul Bolin favorably reviewed in January 2004, the 25th Anniversary Focus SE is considerably more refined. It uses an AMT supertweeter and a leaf tweeter, between two unique 7" midrange units that use a cone comprising a sandwich of Rohacell and a weave of silver wire and graphite. The two 12" woofers take over below 200Hz and have a low-Q ported alignment to take advantage of the usual room gain without booming. Frequency range is specified as 16Hz–30kHz and sensitivity a very high 95.4dB (4 ohm impedance).

The cabinet is narrower and deeper than the older speaker's, with sculpted edges that progressively reduce the baffle width for the HF drivers to optimize diffraction. The crossover uses Solen metalized polypropylene capacitors and braided silver Kimber Kable is used to connect the supertweeter. The drive-units are matched to within ±0.25dB and designer Bill Dudleston hand-tunes the crossover network of each SE speaker.

John Atkinson  |  Jan 12, 2011  |  1 comments
Hansen's cost-no-object speakers have always sounded excellent at CESes, so one of the first rooms I visited at the Venetian was Hansen's, to hear the new The King E (for Enlightened) loudspeaker ($98,000/pair). A 63"-tall, 6-driver, 3-way design weighing 420lbs, The King E was being driven by Tenor mooblocks and preamp, with the front-end a Clearaudio turntable fitted with a Graham Phantom II tonearm. (My apologies for not noting the phono cartridge being used.)

Listening to a 45rpm remastering of Manuel de Falla's The Three-Cornered Hat, I was struck by the effortless sweep of sound and low-frequency performance that suggested that The King's specified frequency response of 18Hz–23kHz was not hyperbole. Percussion and pizzicato strings had a start-stop character that was very lifelike, with not a hint of overhang or boom.

John Atkinson  |  Jan 12, 2011  |  0 comments

Bluebird Music's Jay Rein wanted to hear the Bluetooth-driven Chordette Gem-based system at the front of the room, with Spendor A6 speakers, but my attention was drawn to the familiar-looking speakers at the other end of the room, Peak Consult El Diablo Vs ($89,000/pair), which Michael Fremer reviewed in May 2007. Jay explained that he is ow the North American distributor for these Danish speakers.

The speakers were being driven by Chord SPM1400 monoblocks ($$32,900/pair) and a Chord CPS5000 preamp, with van den Hul's new Mountain interconnects and Nova speaker cables. Jay put the Reference Recordings CD of Scheherazade (RR-89CD) with Jose Serebrier conducting the London Philharmonic Orchestra into the Chord Red Reference Mk,II CD player ($25,900) and for an all-too-brief interlude, I was transported from the fake glitz of Las Vegas into the more real sonic world of the Arabian Nights.

John Atkinson  |  Jan 12, 2011  |  0 comments
AAudio Imports' Brian Ackerman holds what must the world's most expensive AC strip, the Weizhi PRS6. Priced at $3200, the PRS6 is machined from a block of Super Duralumin alloy and features a graphite grounding module. There are no isolating transformers or conditioning circuits, the PRS6 is purely passive. The thinking behind the product, said Brian, is "to get the noise out of the line without changing the sound."

Yes, the Weizhi is a gorgeous piece of audio jewelry but do people really pay $3200 for peace of mind? Brian told me that he is currently shipping 10 units a week, so I guess they do.

John Atkinson  |  Jan 02, 2011  |  First Published: Jun 02, 1989  |  3 comments
Externally, the LHH1000 came as a bit of a surprise to these jaded eyes, over-familiar with plain black or brushed-aluminum boxes. Each enclosure is finished in an almost white, anodized finish, with greenish-gray endcaps (made from zinc alloy, I believe) painted with a nubbly, crackle finish—an attractively utilitarian styling with shades of military-surplus radio equipment, nicely set off by subdued blue fluorescent readouts. Internally, the units are constructed to audiophile standards. The transport uses Philips's top CDM-1 mechanism, which is fabricated from diecast aluminum, compared with the plastic CDM-4 mechanism which appears in less expensive and less well-specified players. The loading tray, too, which is made from metal, has a reassuringly solid feel to it.

Pages

X