The Freudian Id Stereophile Forums.

Happy 040108!

Warning about the translator site, etc...

OK, I got the SET bug.

Today's the day I hook up my new SET 2A3c amp.

The amp is three watts per channel, well, four with 10% THD.

I'll be using it with some Apogee ribbons. The Apogee dips to one ohm resistance, and is 86dB 'sensitive.'

So, if 1 watt gives me 86 dB, but the amp output doubles its output with every halving of the resistance, then...

My four watt amp should give me 8 watts at four ohms, 16 watts at two ohms, and 32 watts at one ohm.

Therefore...

Hola,

I decided to finally take the plunge and biamp my Lowther DX-3's.

I went out and overspent on a new SET using genuine Western Eclectic 300B's, but now I can't for the life of me find where the tweeter hook ups are on the damned speaker.

I mean, I can find the main speaker hook up, and it looks almost like to goes right the the back of the speaker cone...but I can't find where the woofer and tweeter part diverge so I can hook up the two amps.

A little help?

We at D.A.R.T.[Definative anal retentive technology] have developed with much help from Sterophile beta testers. Our new isolation unit to fully decouple audiophile from listening room. Our zercron incrusted spiked isolation chair features a highly polished chrome isolator mounted to center of isolation chairs seat. Audiophile sits on mount rotates slightly till well seated. Deep detailed pure sound will be your reward. Get one while its hot;) And happy april 1st

After reading the new issue of Stereophile and going through the recommended gear i find it some what strange that a Tri Planar arm has not been reviewed by your rag. What gives.

Another question, was wanting to know if it is possible to hook a single cd player to two recivers at once and play both of them at the same time. I know it sounds silly, but I have an old Realistic STA2000 Reciver and wanted to use it for something, and if this works I can add more speakers to my system.

I'm not entirely satisfied with the 6L6GC tubes in the Leben (using Winged Cs now; good balance but sounds recessed) or the EL34s (again, Winged Cs: way too forward, especially in treble & mids, too mid-range-y & typically "tube-y" & extroverted in sound)

Have a question on hooking up a power amp to a HK 4385 reciever. I need a power amp to run 2, F-3 Klipsch speakers and was going to run a seperate amp for each speaker. Could someone tell me exactly how these would connect to my reciever. I know you use the pre-outs and one would go to the L out and the other to the R out. Does anything thing come back from the amps to the recievers main in connections. I would like to know the wiring configurations before I order these amps.