Opinions on tweaks I made
-Removed bottom cover
-Applied some Dynamat to the under side of the plinth, the suspension brackets and arm board. (2-3hz suspension rate seams OK with the added weight)
-Used WD-40 to get the bearing out of the spindle, cleaned it and use synthetic motor oil when I put it back
-I wrapped the arm a bit (electrical tape)

Systemdek appears to have made 2 different spindle shafts. one smoth and one with a spiral groove. I assume the groove makes sure oil is moved all arouind the shaft? I use the spiral grooved one.

Hello,

my pair of CDM1 - bought in 1998, seldom and always played with low levels - has a very weak treble response.
Testing with white noise shows a sharp frequency cut off below 8 kHz, whereas nominal cross-over is 3 kHz.

A German B&W-group manager told me the tweeters' ferrofluid might have become thick so the coils would not be able to swing easily enough.
He told me this would be the result of thermal overload due to too high amplifier output.

Hello,
I recently inherited a SPR51 (Bush Transistorised Record Players). I know next to nothing about the technology and was wondering if anyone could tell me perhaps approximately when it might have been manufactured? Or any other relevant information about the product?

Thankyou

Hi
if you know farsi you can see my blog