Recommended Components

Recommended Components: 2019 Fall Edition FM Tuners & Antennas

FM Tuners

A

DaySequerra FM Reference Signature Modification: $3200 (+ cost of tuner) ★
David Day's Signature Mod effectively addresses this ultimate FM tuner's cathode-ray tube's tendency to burn out. Switching circuitry has been added to allow the CRT to turn off when not needed. The Signature Mod also replaces the tuner's incandescent bulbs with longer-lasting LEDs, and uses hand-matched, low-group-delay filters for lower distortion and better channel separation. LG noted punchy, quick bass response, a deeper soundstage, and a more transparent midrange. "The new CRT's greater range of brightness and longer life expectancy makes the Signature Modification essential for owners of the DaySequerra FM tuner." The FMR25 upgrade replaces older models' cathode-ray tube display circuitry with a much brighter and more reliable thin-film-transistor liquid-crystal display, and adds a post-FM demodulation filter to remove noise at 99kHz and above. "A run-don't-walk upgrade for owners of FM References," decided LG. Price is for upgrade only; does not include cost of tuner. (Vol.12 No.6, Vol.14 No.12, Vol.21 No.6, FM Reference; Vol.29 No.9, Signature Modification; Vol.36 No.11 25th Anniversary Edition WWW)

D

Magnum Dynalab 205 Signal Sleuth FM Booster: $499 ★
We've left this on the list forever, because there's not much for FM fans these days, and because this unusual, niche product has shown amazing staying power. This is not your typical powered antenna amplifier. It's a notch filter that precedes the tuner with 18dB/octave edges, so it amplifies only the signal you want—sort of a pre-tuner tuner with selective gain. You can use it to attenuate signals that are too strong, and if you want to hear stations that are easy to receive, there's a pass-through. Best with old-fashioned analog radio signals. (Vol.10 No.6)

Deletions
Tivoli Audio Model One table radio.

COMMENTS
Charles E Flynn's picture
Submitted by Charles E Flynn on September 19, 2019 - 7:40pm

From https://cdn.stereophile.com/content/recommended-components-2018-edition-how-use-listings :

Class K

"Keep your eye on this product." Class K is for components that we have not reviewed (or have not finished testing), but that we have reason to believe may be excellent performers. We are not actually recommending these components, only suggesting you give them a listen. Though the report has yet to be published in certain cases, the reviewer and editor sometimes feel confident enough that the reviewer's opinion is sufficiently well formed to include what otherwise would be an entry in one of the other classes, marked (NR).

Enrique Marlborough's picture
Submitted by Enrique Marlborough on September 20, 2019 - 10:27am

Could you add the year of entry to these lists.

Jason Victor Serinus's picture
Submitted by Jason Victor Serinus on September 20, 2019 - 10:33am

It's there.

prerich45's picture
Submitted by prerich45 on September 20, 2019 - 10:01am

When did the Pulsars go up from $7k/7.7k to $9k?!!!!!!!!! That's a huge increase!!!!!!

Bogolu Haranath's picture
Submitted by Bogolu Haranath on September 20, 2019 - 10:14am

The new Pulsar2 Graphene are $9k :-) ..........

brians's picture
Submitted by brians on September 20, 2019 - 8:59pm

I always found it really odd that Stereophile never links the recommended component to its referenced review(s). Really odd, and kind of charming.

AaronGarrett's picture
Submitted by AaronGarrett on September 21, 2019 - 6:08am

Are the headphones pictured Sennheiser 800s? Is this a secret recommendation since they aren't on the list?

stereoGoodness's picture
Submitted by stereoGoodness on September 21, 2019 - 1:53pm

How in the world can the TotalDac still be listed as a Class A+ digital processor? The device's proponent on the Stereophile staff was Michael Lavorgna, who has since been let go by the magazine.

The TotalDac was never properly reviewed by Stereophile, likely because the device's creator knew that it would measure horrendously. Audio Science Review confirmed its terrible engineering, and TotalDac is now closely associated with how audiophilia can go badly wrong.

https://www.audiosciencereview.com/forum/index.php?threads/review-and-measurements-of-totaldac-d1-six-dac.8192/

John Atkinson's picture
Submitted by John Atkinson on September 21, 2019 - 3:14pm
stereoGoodness wrote:
The TotalDac was never properly reviewed by Stereophile, likely because the device's creator knew that it would measure horrendously.

I don't routinely measure the products reviewed in the magazine's columns, but in hindsight I wish I had have done so with the Total DAC. Even so, back in the day I spent a very pleasant afternoon listening to Michael Lavorgna's system with this DAC.

stereoGoodness wrote:
Audio Science Review confirmed its terrible engineering, and TotalDac is now closely associated with how audiophilia can go badly wrong. https://www.audiosciencereview.com/forum/index.php?threads/review-and-measurements-of-totaldac-d1-six-dac.8192/

Oh my!

John Atkinson
Technical Editor, Stereophile

Bogolu Haranath's picture
Submitted by Bogolu Haranath on September 22, 2019 - 5:01am

Ne casse pas le verre :-) ..........

Bogolu Haranath's picture
Submitted by Bogolu Haranath on September 23, 2019 - 12:28pm

'We (at, Stereophile) choose truth over facts' :-) .........

JRT's picture
Submitted by JRT on September 22, 2019 - 8:04pm

"TotalDAC" was a wrong-headed approach in engineering, is grossly overpriced for its performance, is grossly over-hyped in its niche market, and it objectively measures very much worse than lower priced DACs. It is a poor solution, and represents poor value.

However, I also think that there is another larger consideration in this that was missed.
No small of number of people like the sound, people who critically listen to their system and to changes in their system.

So a key take-away is that "TotalDAC" provides a good example of the importance of better perceptual weighting in objective measurements. The simple fact that so many seem to like the sound of this "TotalDAC" regardless that it measures so poorly shows that a large body of critical listeners are highly tolerant of its imperfections that show up clearly in objective measurements.

Note that Amir Majidimehr gave it a bad review because of poor objective measurements resulting from poor choices in engineering, but he did not find the resulting sound highly objectionable in his listening tests. Similarly, John Atkinson and Michael Lavorgna were not displeased with the sound in Lavorgna's system. And there seems to be many others.

Since so many critical listeners are highly tolerant of the imperfections of "TotalDAC", and since there are many inexpensive DACs that outperform it, I would suggest that the DACs should receive a rather low weighting in budget allocation. The opportunity cost on this expensive DAC is far too high, could be better spent in something that matters very much more in perceptual weighting such as loudspeakers, a bespoke low frequency (sub-Schroeder) subsystem, improvements in room acoustics, etc.

JRT's picture
Submitted by JRT on September 22, 2019 - 1:27pm

Wasting budget resources on expensive esoteric cable assemblies brings little if any performance improvement, and in comparison to moderate cost well engineered solutions the esoteric cable assembles can sometimes degrade system performance.

https://www.stereophile.com/content/adcom-gfa-7805-five-channel-power-amplifier-cable-issues

https://sound-au.com/cable-z.htm

Bogolu Haranath's picture
Submitted by Bogolu Haranath on September 22, 2019 - 2:10pm

Regarding sound quality ........ See Stereophile review and measurements of BorderPatrol DAC SE $995 to $1,850 ........ Somewhat similar suboptimal measurements as the TotalDAC ....... Costs lot less ....... Several reviewers liked that BorderPatrol DAC's sound :-) ........

JRT's picture
Submitted by JRT on September 23, 2019 - 4:57am

You get a good DAC and also a good headphone amplifier, plus can be utilized for making objective measurements.

https://www.rme-audio.de/en/products/adi_2-pro.php

Maybe add an inexpensive 2x2 AES/EBU Dante bridge such as the one at the following link.

https://www.bhphotovideo.com/c/product/1417856-REG/audinate_adp_aes3_au_2x2_2x2_dante_avio_aes3.html

Bogolu Haranath's picture
Submitted by Bogolu Haranath on September 23, 2019 - 6:52am

The Chord Mojo ($570, reviewed by Stereophile) and the Chord Hugo2 ($2,695, reviewed by Hi-Fi News), also are, good quality DACs and headphone amplifiers :-) ..........

Bogolu Haranath's picture
Submitted by Bogolu Haranath on September 23, 2019 - 7:12am

Benchmark DAC3 HGC ($2,199, reviewed by Stereophile, Class-A+) is a DAC, pre-amp and headphone amp :-) ...........

JRT's picture
Submitted by JRT on September 23, 2019 - 8:56am

Those lack AD converters.

Seems like a lot of money to spend for simple DA conversion and an output buffer to drive headphones.

Bogolu Haranath's picture
Submitted by Bogolu Haranath on September 23, 2019 - 9:03am

How many Stereophile readers use/want a AD converter? :-) .........

Benchmark also sells a headphone amp/ pre-amp HPA-4 ($3,000, reviewed by Hi-Fi News) :-) ..........

JRT's picture
Submitted by JRT on September 23, 2019 - 4:48pm

For one example group, I suspect some need AD converters to capture the output of their phono preamp to FLAC files.

Bogolu Haranath's picture
Submitted by Bogolu Haranath on September 23, 2019 - 6:53pm

How many Stereophile readers want/use AD converters? ......... may be 5% to 10% .......... Which means 90% to 95% Stereophile readers don't want/use and are not interested in AD converters :-) ..........

Stereophile reviewed Ayre Acoustics QA-9 AD converter ....... I think JA1 and MF still sometimes use that Ayre AD converter :-) ........

Stereophile has also reviewed USB output turntables from Sony and Music Hall, which obviously have built-in AD converters :-) .........

Bogolu Haranath's picture
Submitted by Bogolu Haranath on September 23, 2019 - 7:46pm

BTW ....... Don't post any comments about AD converters on AnalogPlanet ....... Stereophile readers are more tolerant people :-) ........

Bogolu Haranath's picture
Submitted by Bogolu Haranath on September 24, 2019 - 7:02am

Seems like MF is currently using one of the Lynx Hilo AD/DA converters ......... Some of these Lynx products are available at Sweetwater ........ May be JA1 could review one of these AD/DA converters currently available :-) ........

Bogolu Haranath's picture
Submitted by Bogolu Haranath on September 23, 2019 - 9:12am

Benchmark also sells just a DAC ..... DAC3-B for $1,699 :-) ...........

Bogolu Haranath's picture
Submitted by Bogolu Haranath on September 23, 2019 - 9:47am

There are other less expensive DA converters/headphone amps ........ Pro-Ject Pre-Box S2 ($399, reviewed by Stereophile), AudioQuest DragonFly Black and Red ($99 and $199, reviewed by Stereophile) and DragonFly Cobalt ($299, Stereophile review may be forthcoming) :-) ...........

Bogolu Haranath's picture
Submitted by Bogolu Haranath on September 23, 2019 - 11:13am

Schiit Audio makes several headphone-amps/DACs, from $99 to $499 :-) ..........

Bogolu Haranath's picture
Submitted by Bogolu Haranath on September 23, 2019 - 1:19pm

The new iBasso DC01 and DC02, DAC/headphone-amps $75 to $79 :-) ..........

Charles E Flynn's picture
Submitted by Charles E Flynn on September 22, 2019 - 4:25pm

You are now officially on your own when it comes to the purchase of a table radio.

Bogolu Haranath's picture
Submitted by Bogolu Haranath on September 22, 2019 - 4:39pm

Get a Naim Mu-so2 or Qb2 ....... EISA award winner .......Kinda table radio ....... See, S&V review on their website :-) .........

listentomusic's picture
Submitted by listentomusic on September 23, 2019 - 12:32am

does someone know why is simaudio 340i is gone from the list.it was there is last 2-3 lists

Jim Austin's picture
Submitted by Jim Austin on September 23, 2019 - 7:15am

By long tradition and with some exceptions, components are removed from the list when they have not been auditioned for more than 3 years. The tradition arose from print, and the limited space it allows; this practice could be relaxed online, but then we would have two different lists. (The exceptions, usually, are cases in which a Stereophile reviewer has continuing experience with the product, as when it is part of a reviewing system, and so can continue to vouch for it.)

Jim Austin, Editor
Stereophile

Bogolu Haranath's picture
Submitted by Bogolu Haranath on September 23, 2019 - 8:14am

Jim Austin is the perfect reviewer for the new Revel Performa top-model, F328BE ($15,000/pair), and compare them to the Revel Ultima Salon2 :-) ............

X