Larry Greenhill

"The technology to create a full, wireless, 5.1 channel audio system simply wasn't available before, "said Mike Gough, B&W's Senior Project Manager on the Liberty System, "so we waited until it was possible to do it right." The Liberty employs a proprietary, robust wireless protocol with channel switching capabilities—called dynamic channel selection—to avoid interference from existing WiFi networks. Its wireless transmitter broadcasts 8 separate channels, allowing for full 5.1 in one room, and a stereo setup in a second room. Alternatively, the Liberty can support 4 separate stereo zones throughout the house.

Each Xs channel has two chassis, one for the power supply and the other for signal amplification. The amplifier acts as a voltage source, and is rated at 300W into 8 ohms, 600W into 4 ohms, and 1200W into 2 ohms. It is biased to ensure make certain that the amplifier remains in class-A mode into all loads. Each channel has 122 output devices with a total rating of 10kW, and the extensive heatsinking allows the Xs 300 to deliver 2kW into a load "all day long." Though the Xs 300 stack was a silent exhibit, the company was using the more modest $65,000/pair Xs 150s to drive the Pass Lab RM2 loudspeakers, which showed a wide dynamic range and outstanding detailing.

Ron Sutherland of Sutherland Engineering taught me all I need to know about Nixie tubes at CES. Used as the main visual display device used in his Reference N-1 preamplifier and in his Destination Line-Stage preamplifier's control unit shown in the photo, the Nixie tube was invented in 1955 as the first electronic display tool for reading out the numbers 0–9. The Nixie's designers fashioned a wire mesh into 9 layers, each layer in the shape of a number, resulting in a tidy small stack. This tiny wire stack was inserted into a small glass envelope, filled with neon gas, and then sealed. When any of the separate metal layers was charged with 175 volts, the neon gas around the wire ionized, and lit up. When plugged into a circuit board, the tube would read out the numbers, with each number appearing at a different depth. Paul was fascinated with the retro look of this type of readout, so he has installed it in his $15,000, three-chassis Destination line stage, and into his new $10,000 reference N-1 preamplifier.

T+A's lively and energetic Jochen Fabricius was eager to fill me in on the new, 3-way, 183 lb, $55,000/pair T+A CWT 1000-8 SE floorstander. This speaker uses a 25" by 2" electrostatic line tweeter that covers the frequency range from 2kHz to 40kHz.