Velodyne DF-661 loudspeaker System context

Sidebar 2: System context

Power amplifiers used to drive the Velodynes were either a pair of Mark Levinson No.20.6 monoblocks or a YBA 2 HC, while the preamplifier was variously the Melos SHA-1 headphone amplifier used as a line-stage, the YBA 2, the Classé Six Mk.II, the remote-controlled Mark Levinson No.38, or the very promising McCormack TLC-1 buffered passive control unit. A Mod Squad Phono Drive EPS amplified LP signals from a Linn Sondek/Cirkus/Trampolin/Lingo/Ekos/Arkiv setup sitting on an ArchiDee table. Digital source was a Mark Levinson No.30 driven by a Mark Levinson No.31 transport via Madrigal AES/EBU cable.

Interconnects used were all AudioQuest's AudioTruth Lapis x3; while speaker cable was a bi-wired set of AudioTruth Sterling. All source components and preamps were plugged into a Power Wedge 116, itself plugged into one of my listening room's two specially installed dedicated AC circuits and fitted with the Power Enhancer option.

The Velodynes were used atop the lead-shot–filled, 24" Celestion Si Celestion stands, interfaced to the stand top-plates with small Blu-Tack pads. The stands were spiked to the tile-on-concrete floor beneath the carpet and pad.

My dedicated room measures approximately 19' by 16.5', with a 9' ceiling. The wall behind the speakers is faced with books and LPs, while further book- and CD shelves occupy the positions on the sidewalls where the first reflection from each speaker would occur. The room is carpeted, and there are patches of Sonex foam on the decking'n'viga ceiling to damp the first reflections of the sound. The other wall has RPG Abffusors and ASC Tube Traps behind the listening seat to absorb and diffuse what would otherwise be early rear-wall reflections of the sound that might blur the stereo imaging precision. More Tube Traps are used in the room corners to even out the room's bass resonances, the result being a relatively uniform reverberation time of around 200ms from the upper bass to the mid-treble, falling to 150ms above 10kHz. The room sounds relatively dry, without a lot of bass bloom, but is extremely articulate.

I listened to the Velodynes both in my room and in Stereophile's listening room (see Vol.14 No.10, pp.103–107) as a check on my findings. In the latter, I used a C.E.C. CD transport, Mark Levinson No.35 D/A processor and No.38 preamplifier, a Krell KSA-300S amplifier, and a mix of Cardas and Straight Wire cables.—John Atkinson

COMPANY INFO
Velodyne Acoustics, Inc.
1070 Commercial Street, Suite 101
San Jose, CA 95112
(408) 436-7270
ARTICLE CONTENTS
Share | |

X
Enter your Stereophile.com username.
Enter the password that accompanies your username.
Loading